Clear Casting Catalyst
This is the hardening catalyst for use with Castin' Craft Clear Casting Resin. The catalyst MUST be combined with the casting resin for any hardening to take effect. The following is a guide to the recommended ratios for use of casting catalyst with clear casting resin: Formula for one layer: if layer is 1/8 in. thick, use 15 drops per ounce of resin. If layer is 1/4 in. thick use eight drops per ounce. If layer is 1/2 in. thick, use six drops per ounce. If layer is 3/4 in. thick, use five drops per ounce. If layer is 1 to 1-1/2 in. thick use 4 drops per ounce. For multi layer projects (especially when embedding items into it): first layer use five drops per ounce, for the second layer use four drops per ounce, for the third layer use three drops per ounce and for additional layers use two drops per ounce. Ask a question about Clear Casting Catalyst Ask a question about this product | See all questions & answers (2) Average User Rating: Based on (9 Reviews) Jeanne W. from Glen Ellen, CA says: I am a novice at resin casting but found the Environmental Tech products to be easy to use. The instructions were very clear and with minimal experimentation I was able to get it right. Please wait...
You May Also Like...
How to get VIP Club Prices
Anyone can be a VIP Member with:
Product Questions and AnswersAsk a Question
Ask a Question
Would it be a bad idea to use Castin' Craft Resin Catalyst in a resin mix? - Asked by Pam Shipman on 24-May-13
Answer
The CastinCraft Catalyst can be used with the CastinCraft Resin. - Answered by MisterArt on 24-May-13Does this dry clear? - Asked by Christi on 04-Nov-12
Answer
Yes, Castin' Craft Clear Casting Resin does dry clear. - Answered by MisterArt on 08-Nov-12Ask a Question About Clear Casting Catalyst
Your email will not be shared. We will only use your email address to respond to your question.
When asking your question, please be as descriptive as possible, it will allow us to give you the most accurate answer possible.
|
||||||||||||||||||||
Please wait...
Please wait...
|